A rotten or broken deck board is a safety problem and an easy fix. Lone Star Trailer Parts stocks treated lumber for trailer decks in Mount Pleasant, Texas. Call 903.572.0288.

Lumber we stock

Size Lengths
2 x 6 treated 8, 10, 12, 14, 16, 18, 20 and 24 ft
2 x 8 treated 10, 12, 14, 16, 18, 20 and 24 ft

Pick the length that matches your deck so boards run the full length without a joint, or cut to fit for cross-laid decks.

Replacing deck boards

  1. Remove the old fasteners. Self-tapping deck screws or carriage bolts are common.
  2. Check the crossmembers underneath for rust and cracks while the deck is open.
  3. Lay new boards with the crown (the curve of the growth rings) facing the right way for your deck, and leave a small gap for drainage.
  4. Fasten into every crossmember with new hardware.

Making a deck last

  • Treated lumber resists rot, but water still does damage. Let the deck drain and dry.
  • Don’t park on wet ground for weeks at a time.
  • Replace a cracked board before a load goes through it.

More for equipment trailers

Equipment trailers take a beating at the ramps and dovetail. See our equipment trailer parts guide for decking, stake pockets and D-rings, and gates and ramps for loading.

Pickup and freight

Lumber is bulky. Pick it up at our Mount Pleasant warehouse, or call to ask about freight before ordering.

Hardware and crossmembers

Most decks are held down with self-tapping deck screws or carriage bolts into the steel crossmembers. Use new fasteners when you replace boards; old ones are often rusted thin. While the deck is open, check each crossmember weld and repaint any bare steel.

Questions

2×6 or 2×8?

Both are common on utility and equipment trailers. Match what’s on your trailer now so the fasteners and crossmember spacing line up.

Do you sell deck screws?

Call us for hardware with your lumber order.