Trailer leaf springs come in two main types, and they use different hangers. Here’s how to tell which you have and how to measure for a replacement.
Double-eye springs
A double-eye spring has a rolled eye at both ends. The front eye bolts to a front hanger; the rear eye connects to a shackle that swings as the spring flexes. On tandem trailers, the inner eyes connect through an equalizer. Most 3,500 lb utility trailers use double-eye springs.
Measure: center of one eye to the center of the other.
Slipper springs
A slipper spring has an eye at the front only. The rear end is flat or hooked and slides in a slipper hanger. Slipper springs are common on heavier trailers.
Measure: center of the eye to the end of the spring.
How many leaves?
More leaves carry more weight but ride stiffer when the trailer is empty. Match the leaf count to what’s on the trailer now, unless you’re increasing capacity. We stock 2-, 3-, 5- and 6-leaf slipper springs and 4-, 5- and 6-leaf double-eye springs.
Can I switch types?
Not without changing the hangers. A slipper spring needs a slipper hanger; a double-eye spring needs a shackle. Replace springs in pairs on an axle so both sides ride the same.
What else to replace
While the springs are off, look at:
- U-bolts: don’t reuse them; buy a new kit sized to the axle tube (2-3/8 in. or 3 in.)
- Hangers: check welds for cracks
- Equalizers and shackles: look for worn bushings and bolts
Dexter’s schedule calls for inspecting springs for wear and loss of arch, and hangers for weld integrity, every 12 months or 12,000 miles.
Parts
See leaf springs, hangers and U-bolts, or call 903.572.0288 with your measurements.
Questions
Why does my trailer sit lower on one side?
A broken leaf, a flattened spring or a broken hanger. Replace the springs in pairs.