Wheel bearings let the hub spin on the spindle. They’re the most common trailer breakdown, and almost always because they ran out of grease or took on water. Here’s how to keep them right.

Common bearing numbers

Axle Inner bearing Outer bearing
3,500 lb L68149 L44649
5,200 lb 25580 15123
6,000 to 7,000 lb 25580 14125A

Each bearing (cone) runs in a race (cup) pressed into the hub. Always check the numbers on the old bearing; trailers built with other axle brands may differ.

How often

Dexter’s maintenance schedule calls for inspecting wheel bearings and cups for corrosion or wear, then cleaning and repacking them, every 12 months or 12,000 miles, and replacing any seal you remove. (Dexter maintenance schedule) Boat trailers that go in the water need more frequent attention.

Signs of a failing bearing

  • A hub that’s much hotter than the others after a drive
  • Grinding or rumbling, or wobble when you rock the tire top and bottom
  • Grease slung on the inside of the wheel (a failed seal)
  • Blue or pitted bearing rollers or races

Repacking, step by step

  1. Jack up the trailer safely and support it on stands.
  2. Remove the dust cap, cotter pin, spindle nut and washer, then the hub.
  3. Remove the seal and inner bearing. Clean everything and inspect bearings and races.
  4. Replace any pitted or discolored bearing together with its race.
  5. Pack the bearings with wheel bearing grease, working it through the rollers.
  6. Install the inner bearing and a new seal, put the hub on, then the outer bearing, washer and nut.
  7. Adjust the spindle nut to the axle maker’s procedure, lock it with a new cotter pin, and install the dust cap.

EZ Lube spindles

Dexter’s EZ Lube spindles have a grease fitting in the end so you can add grease without pulling the hub. It’s convenient, but it doesn’t replace inspecting the bearings on schedule.

Parts

We stock bearings, races, seals, dust caps and complete hub kits (hub or drum, both bearings, seal, dust cap and lug nuts). See hubs, drums and bearings.

Questions

Should I replace both sides?

If one bearing failed from lack of grease, check the rest; they had the same maintenance.

Can I reuse a seal?

No. Dexter’s schedule says to replace any seal that’s been removed.